Evoqua WALLACE & TIERNAN MFC, Instruction Manual

Page: 143 / 268

MFC
Operation
5.
143
Module designation Module 1 to 4 Max. 6 digits, customised entry
If blanks are entered, the module
description is switched off.
System reset System restart
4)
yes / no
Delete graph
5)
yes / no
Standard value
6)
yes / no
Delete dos. avg
7)
yes / no
Dosing Factors
8)
0–100 %
Please note
The system settings marked with 1) to 8) are explained below.
Explanation of system settings
1)
Measure Filter The dampening serves to compensate measurement value
fluctuations in the event of irregular measurement value signals.
2)
Feed delay The feed delay delays dosing start when the device is switched on
and when the operating mode has been changed. Running of the
selected time can be cancelled with the "Acknowledge" key.
3)
Samp.water delay The sample water delay (DI 1) determines the time after which
dosing is deactivated, e.g. in the event of sample water stop. DI 1
flashes while the delay time is running.
4)
System restart When the applications are changed, the device must be restarted
with System Restart.
5)
Delete graph Deletes the values saved in the past 7 days.
6)
Standard values Deletes customer settings (except for the selected application),
resets system to factory settings. The sensors must be
recalibrated.
7)
Delete dos.avg Resets the average dosing values from display 1.8.3 to zero.
8)
Dosing Factors Resets the dosing factor table to the set value and all training
meters to zero.