Evinrude 4906B 4HP 1969, Owner'S Manual

Page: 129 / 422

4-38 FUEL
4-9 ASSEMBLING CHOKES
TO TYPE
n
CARBURETORS
Perform only one of the three following
choke installation procedures, depending on
the type of unit being serviced. After the
choke and carburetor have been properly
installed onto the engine, proceed directly
to the adjustment portion of this section to
operate the engine for testing and carbure-
tor adjustments under load.
Heat/Electrical Choke Installation
1- Install the choke plunger and spring
by hooking the spring into the choke lever.
2- Insert a NEW gasket into the cavity
of the choke base.
3- Insert the spring into the bore of the
choke solenoid.
4- Work the choke solenoid up the plung-
er and secure the plunger with the two
retaining screws.
.5- Place a NEW gasket onto the surface
of the carburetor. Install the choke cover
onto the carburetor. Observe how the
spr ing has a clip and t he choke lever has a
protrusion. The clip MUST fit around the
lever and protrusion.
6- Align the mark on the cover plate
with the matching mark on the carburetor.
Secure the cover plate in this position with
the three attaching screws.