Evinrude 4906B 4HP 1969, Owner'S Manual

Page: 110 / 422

and slip the spring over the edge of the
float, as shown. Apply just a drop of oil to
the inlet needle and then lower the needle
into the seat. Install a NEW hinge pin
included in the kit.
15- Hold the carburetor in a horizontal
position, as shown, and observe the attitude
of the float. The float must be level
(parallel) with the surface of the carburetor.
If the float is not level, use a pair of needle-
nose pliers and CAREFULLY bend the float
tab SQUARELY until the float is in the
correct position (level with the carburetor).
Check to be sure the float is square with the
carburetor
cavity (one side is not further
away than the other).
16- Place the bowl gasket in position on
the carburetor, and then position the bowl
on top of the gasket. Secure the bowl in
place with the five screws.
FLOAT
-:
J/E CARBURETORS 4-19
17- If a filter is used in the float bowl,
slip the filter down over the center post in
the bowl. Slide the gasket into place in
float bowl. Install and tighten the nut
secu ring the filter in place.
18- Place the glass float bowl in position
on top of the gasket. Swing the hinge into
place and secure it with the thumb nut.
19- Insert three new packing washers
into the high-speed and low-speed cavities.
FilTER
NUT
FilTER