Evinrude 4906B 4HP 1969, Owner'S Manual

Page: 126 / 422

TYPE II CARBURETOR 4-35
6- If the carbureotor being serviced has
a filter bowl attached to the carburetor,
install a NEW filter bowl gasket, NEW filter,
washer and screw at this time.
7- Place the fitler bowl over the filter
and secure it in place with the clamp.
S- Hold the carburetor in a horizontal
position, as shown, and observe the attitude
of
the float. The float must be level
(par rallel) with the surface of the carburet-
or. If the float is not level, use a pair of
needle-nose pliers and CAREFULLY bend
the foat tab SQUARELY until the float is in
the correct position (level with the carbu-
retor). Check to be sure the float is square
with the carburetor cavity (one side is not
further away than the other).
9- Lower the bowl onto the carburetor
and secure it with the four screws.
10- Install the bushing into the low-speed
needle valve opening.
11-
Insert the two fiber washers and the
one nylon washer into the low-speed cavity.
12-
Start the low-speed needle valve
packing nut into the opening. DO NOT
tighten the nut at this time. Thread the
low-speed needle valve into the low-speed