Estun pronet series, User Manual

Page: 92 / 193

ProNet Series AC Servo User's Manual
- 90 -
4.5.8 Encoder Signal Output
Encoder feedback pulses processed inside the servo drive can be output externally.
Type Signal Name Connector Pin Number Name
Output
PAO CN1-20 Encoder output phase A
/PAO CN1-21 Encoder output phase /A
Output
PBO CN1-22 Encoder output phase B
/PBO CN1-23 Encoder output phase /B
Output
PCO CN1-24 Encoder output phase C(zero-point pulse)
/PCO CN1-25 Encoder output phase /C(zero-point pulse)
Host Controller
PG
Encoder
Serial Data
CN2
Frequency
dividing
circuit
CN1
Phase A(PAO)
Phase B(PBO)
Phase C(PCO)
These outputs explained here.
*
Servodrive
*
The dividing output phase form is the same as the standard setting (Pn001.0=0) even if in reverse rotation mode
(Pn001.0=1).
■
Output phase form
If the servomotor is not equipped with an absolute encoder, the servomotor needs two full rotations before using the servo
drive's Phase-C pulse output as the zero point reference.
Dividing: Dividing means that the divider converts data into the pulse density (Pn200) based on the pulse data of the
encoder installed on the servomotor, and outputs it. The setting unit is number of pulses/revolution.