Estun pronet series, User Manual

Page: 124 / 193

ProNet Series AC Servo User's Manual
- 122 -
4.11.2 Rotation Detection Output Signal (/TGON)
Type Signal Name Connector Pin Number Setting Meaning
Output /TGON
CN1-5,CN1-6
(Factory setting)
ON(low level)
Servomotor is operating(Servomotor
speed is above the setting in Pn503).
OFF(high
level)
Servomotor is not
operating(Servomotor
speed is below the setting in Pn503).
This signal output indicates that the servomotor is curently operating above the setting set in parameter Pn503.
·
Related parameter
Pn503
Rotation Detection Speed TGON
Setting range Setting unit Factory setting Setting validation
0
～
3000 rpm 20 Immediately
·
This parameter sets the range in which the rotation detection output signal (/TGON) is output
·
When the servomotor rotation speed is above the value set in the Pn503,the servomotor rotation speed signal
(/TGON) is output.
·
The rotation detection signal can also be checked on the panel operator.
4.11.3 Servo Ready (/S-RDY) Output
Type Signal Name Connector Pin Number Setting Meaning
Output /S-RDY
CN1-9,CN1-10
(factory setting)
ON (low level) Servo is ready.
OFF (high level) Servo is not ready.
·
This signal indicates that the servo drive received the servo ON signal and completed all preparations.
· It is an output when there are no servo alarms and the main circuit power supply is turned ON.
4.11.4 Encoder C Pluse Output (/PGC)
Type Signal Name Connector Pin Number Setting Meaning
Output /PGC
Not including this setting in
the default setting,
please choose terminal
output by setting
parameter Pn511.
ON (low level) With encoder C pluse output
OFF (high level)
Without encoder C pluse
output
This signal indicates when the servo drive circumrotates to the C pulse position; there is a correlation between the width
of the C pulse and the speed of the servo drive.
Position Torque Speed