User Manual
Appendix H
GFK-1742F
Jan 2020
Using VersaPro with the DSM314
505
(the 18th %I bit), and for Axis 2 is the %I offset 33 bit (the 34th %I bit). The resulting
display is shown in Figure 268.
Figure 268: RVTExample Screen
4.
Enable Local Logic by setting the %Q offset 1 bit from the PLC. If there are no errors,
you can then execute the motion programs.
5.
Execute Program 1 by toggling %Q offset 2 bit. The motor connected to Axis #1
should then begin to execute Motion Program #1.
6.
Execute Program 2 by toggling %Q offset 3 bit. The motor connected to Axis #2
should begin to execute Motion Program #2.
7.
The motors will execute the statements until they reach the first DWELL, where you
can visually verify that it followed the CAM profile correctly. The display should be
similar to Figure 269. Notice how the commanded position for Axis#2 equals 2500,
while the commanded position for the slave corresponds to the CAM table and has
the value 10,000.