EMC Connectrix ED-64M, User Manual

Page: 405 / 476

E
perf
E-71
Command Line Interface
◆
Sig Losses — The number of times the port has detected a loss of
signal while not in an offline or LF2 state.
Output Example The output from perf.link is similar to the following:
perf.thresholdAlerts
The perf.thresholdAlerts commands are standard command line
interface features; they do not require a feature key. You can configure
up to 16 threshold alerts, including both counter threshold alerts and
throughput threshold alerts. For a list of the available threshold alerts
counters, refer to Table E-3.
In order to activate a threshold alert using the CLI, you must enter a
certain commands in order. Enable a threshold alert using the
following order:
1. Create a counter threshold alert using
perf.thresholdAlerts.counter.addAlert . (Refer to
perf.thresholdAlerts.counter.addAlert on page E-73.) Create a name
for the threshold alert that you can use in subsequent commands.
The threshold alert must then be configured using the other
counter threshold alert commands.
2. Associate the threshold alert counter with the threshold alert
name using perf.thresholdAlerts.counter.setCounter. (Refer to
perf.thresholdAlerts.counter.setCounter on page E-76.)
3. Configure the threshold alert using other perf.threshold alert
commands. For example, you should assign the threshold alert to
a port using perf.thresholdAlerts.counter.addAlert. (Refer to
perf.thresholdAlerts.counter.addPort on page E-74.)
Port 2 Statistic
-----------
OLS In
OLS Out
Reset In
Reset Out
Link Flrs
Sync Losses
Sig Losses Count
----------
753452
351269
2953184
1842953
2953184
1842953
35246