EMC Connectrix ED-64M, User Manual

Page: 408 / 476

E
E-74
Connectrix ED-64M User Guide
Command Line Interface
Parameters This command has one parameter.
Command Example
Root> perf thresholdAlerts counter addAlert Checklinks
perf.thresholdAlerts.counter.addPort
Syntax
addPort name portNumber
Purpose
This command adds a port to the specified counter threshold alert.
Parameters This command has the following parameters.
Command Example
Root> perf thresholdAlerts counter addPort linkresets 12
name
Specifies the name of the new counter
threshold alert. This name can consist of any
ASCII characters up to a maximum length of 64
characters. To use spaces or special characters
in this name, put quotation marks around the
name. This parameter is case-sensitive.
name
The name of a counter threshold alert as
defined by the command
perf.thresholdAlerts.counter.addAlert.
(Refer
to perf.thresholdAlerts.counter.addAlert on
page E-73.)
portNumber
Specifies the port number or port type. Valid
values are either a single port number, all
ports, or port type.
The following port numbers are valid:
0
through 63, or all, which applies the counter
threshold alert to every port on the product.
Specifying a port type removes all the ports
from the alert and applies the alert to each port
that is the specified type of port. Valid values
for the ED-64M are eport and fport.
A counter threshold alert is not allowed to
specify both port types and individual port
numbers.