EMC Connectrix ED-64M, User Manual

Page: 376 / 476

E
E-42
Connectrix ED-64M User Guide
Command Line Interface
Output The director configuration data is displayed as a table that includes
the following properties
◆
Authentication Traps — The state of the authentication traps (for
example, enabled) that are sent to SNMP management stations
when unauthorized stations attempt to access SNMP information
from the director.
◆
Index — The community index number.
◆
Community Name — The name of the community.
◆
WriteAuth — The write authorization state.
◆
Trap Recipient — The address of the trap recipient, in 4-byte
dotted-decimal format.
◆
UDP Port — The user datagram protocol (UDP) port number to
which the director will send traps for each recipient.
Output Example The output from config.snmp.show is similar to the following:
config.switch Some of the config.switch commands require that the director be set
off line. (Use maint.system.setOnlineState to set the director off line.)
If these commands are entered while the director is on line, an error
message results.
config.switch.bbCredit
Syntax
bbCredit bbCreditValue
Purpose This command sets the buffer-to-buffer credit value for all ports,
except those ports configured for extended distance.
Description The director must be off line before issuing this command. Use
maint.system.setOnlineState
to set the director off line.
Authorization Traps: Enabled
Index
-----
1
2
3
4
5
6 Community Name
------------------
CommunityName1
CommunityName1
CommunityName1
public WriteAuth
------------
Enabled
Enabled
Disabled
Enabled Trap Recipient
----------------
123.123.123.123
10.25.25.10
132.44.85.224 UDP Port
---------
162
144
162
162