5
Configuring Ports
5-19
Configuring the Director
Configuring Ports
Use the procedures in this section to configure identification and
operating parameters for director ports. Port configuration data is
stored in NV-RAM on the director.
Follow these steps to configure a port:
1. Click Configure on the Product Manager menu bar and select
Ports
on the drop-down menu.
This displays the Configure Ports dialog box (Figure 5-7).
Figure 5-7
Configure Ports Dialog Box
2. Configure the port parameters, referring to Port Parameters on
3. Click Activate to activate changes and close the dialog box.
If the format for a WWN or Nickname in the Bound WWN
column is invalid, an error message appears.
If the Port Binding column is checked for a port and the WWN or
Nickname in the Port Binding column does not match the device
actually connected to the port, a warning (Figure 5-8) appears,
listing all ports that have a mismatch.
Summary of Contents for Connectrix ED-64M
