Elliott E190, Operation And Maintenance Manual

Page: 277 / 358

2
( 37 & 38 ) and back-up rings ( 39 & 40 )
for damage, replace if necessary. (Ref.
Fig. 2) On 52 series swingdrive inspect
bearing ( 41 ) & seal ( 42 ) in brake
housing ( 15 ) replace if necessary.
10. Remove race (
12 ) from input planet set
( 13 ).
11. Remove input planet set (
13 ) from gear
housing ( 7 ) by pulling straight up and out
of the housing.
12. Remove retaining ring (
13.4 ), press out
the planet pins ( 13.3 ), remove the planet
gear ( 13.2 ), and needle bearings ( 13.5 ),
inspect for unusual wear. Replace as
required.
13. Remove race (
12 ) from output planet set
( 10 ).
14. Remove the output sun gear (
11 ), from
the output planet carrier (10.) . Lift the
output planet set out of the housing (7) .
15. Remove the retaining ring (
10.4 ). Press
out the planet pins ( 10.3 ); remove the
planet gear ( 10.2 ) and needle bearings
( 10.5 ). Inspect for unusual wear.
Replace as required.
16. Remove bearing lock nut (
35 ) and lock
washer ( 34 ).
17. Remove the pinion shaft (
1 ) from the
housing ( 7 ) inspect the pinion shaft,
seal, and bearing for wear and replace if
necessary. Remove the inboard bearing
(
9 ) and inspect for wear.
18. Remove outboard seal (
2 ) and bearing
( 3 ) Inspect for wear and replace if
necessary.