Elliott E190, Operation And Maintenance Manual

Page: 351 / 358

17
Before disassembly, disconnect hoses as described in this manual.
Any residual pressure within the unit can and will spray at
high velocity, injuring the person doing the disassembly. Hot or
pressurized hydraulic fluid will cause serious injury or death.
Complete disassembly is not recommended. Return the unit
to an authorized dealer for total disassembly and/or repair.
WARNING
READ BEFORE DISASSEMBLY
WARNING
Safety
DO NOT attempt to make any changes to any of the component
parts or accessories when connected to the power source.
DO NOT adjust, inspect, or clean tool while the tool is connected
to the power source. The tool could accidentally start up
and cause serious injury.
Complete disassembly is not recommended.
Return the unit to an authorized dealer for total disassembly and/or repair.
All maintenance or disassembly should take place on a flat, clean work surface
covered with towels or wipers so as to have a clean space for the disassembled parts.
Inspect each part during disassembly for wear, scratches, and cuts. Discard the
worn or damaged parts and replace with new parts.
Use only factory specified parts when repairing and/or replacing.
Severe damage to the tool can occur with non-specified parts.
O-rings are sensitive to sharp edges. Inspect closely for cuts or damage. A small
cut will cause a leak. When assembling or disassembling O-rings, use hydraulic fluid
as a lubricant to help disassembly or installation.
The unique plumbing required to integrate the REL-10-I with the PVA-00L3 3-way valve is
custom fitted for each unit, and cannot be purchased for non-factory repairs at this time.
If any unit requires repair or replacement of these parts, please return to
RELIABLE
for factory authorized service .
If you have any questions regarding the information found in this manual please
contact the supervising authority or RELIABLE EQUIPMENT before continuing.
Phone: 215-357-3500 Toll Free: 800-966-3530 Fax: 215-357-9193