Elliott E190, Operation And Maintenance Manual

Page: 348 / 358

14
USE ALL APPROPRIATE AND APPLICABLE PERSONAL
SAFETY PROCEDURES AND EQUIPMENT AS REQUIRED
BY THE OPERATING COMPANY.
Inspect, set-up and connect the tool as described on the
previous pages.
WARNING:
DO NOT connect or disconnect the tool,
hoses, or fittings while the tool is running, hot, or under pressure.
Serious injury or burns could result.
Replace all parts that show signs of wear or damage.
A damaged or improperly assembled tool may injure
operator and/or nearby personnel.
Set up desired operation. (ie. crimp, cut, or spearing).
Review and understand all operation and safety guidelines
relating to the operation to be performed.
Ensure that valve is in the RETRACT position before initiating
hydraulic power souce.
Activate the REL-10-I-SA by moving valve handle to the LEFT
ADVANCE position.
The tool operation will begin immediately.
NOTE:
Moving the valve handle to the HOLD (center) position
will stop the tool action allowing for confirmation and
repositioning as needed.
When relief valve popping occurs desired pressure has
been achieved and operation should be complete.
Repeat as necessary.
NOTE:
Holding valve handle in the ADVANCE position
after relief valve has popped will cause unnecessary
wear on relief valve and pump assembly.
Move valve to RIGHT /RETRACT and allow tool cutting
blades, crimping jaws or ram to return fully.
Valve should be in the RETRACT position when not in use.
REL-10-I-SAD REL-10-I-SAD
REL-10-I-SAD REL-10-I-SAD REL-10-I-SAD S/A OPERA
S/A OPERA
S/A OPERA S/A OPERA S/A OPERATION
TION
TION TION TION
NOTICE
LOW PRESSURE PORTS
(TO POWER SUPPLY)
H/P SINGLE ACTING
PRESSURE PORT
VALVE HANDLE
REL-10-I
INTENSIFIER
PVA-00L3
3-WAY VALVE
PVA-00L3
3-WAY VALVE
H/P DOUBLE ACTING
PRESSURE PORT
DOUBLE ACTING
RETURN PORT
Move valve handle
to desired action
LEFT/ADV (advance)
or RIGHT/RET (retract) return
upon completion
of operation.
If you have any questions regarding the information found in this manual please
contact the supervising autority, or RELIABLE EQUIPMENT before continuing.
Phone: 215-357-3500 Toll Free: 800-966-3530 Fax: 215-357-9193