EBS EBS 2600, User Manual

Page: 171 / 184

171 of 184
EN
EBS‑2600 User Man
ual
G2023/04/26_1EN 2023.05.16
3. Use the cross head screwdriver to remove screw 3h that fastens drip rail 3b to printhead 2 .
Fig. 66.
3g
1x
3h
3b
2
5
3g
3b
4. Pull drip rail 3b out of the guides towards the back of the printer.
Should the removal of drip rail 3b be difficult, it is advisable to loosen or completely remove
slide 5 .
5. Remove ink filter 3g from drip rail 3b , pulling it out of the rail guides upward.
6. Use a paper towel or other material to thoroughly clean drip rail 3b and ink filter 3g .
7. Use the sprayer to spray wash‑up over drip rail 3b and ink filter 3g and then remove the remain-
ing impurities.
When drip rail 3b is removed, it is advisable to clean the ink remnants from the bottoms of
printhead 2 and guides.
8. Fasten ink filter 3g to drip rail 3b .
NOTE: The ink filter must be installed correctly!
Ink filter 3g is a directional element. It must be installed in drip rail 3b in such a way that
the holes are on the bottom surface of the rail (see Fig. 66 ).
9. Push drip rail 3b (together with filter 3g ) into the guides on the bottom side of printhead 2 .
NOTE: The drip rail must be installed correctly!
While installing drip rail 3b make sure that:
‑ It runs parallel to the guides,
‑ It evenly extends about 2 mm beyond the printhead edge.
10. Use the cross head screwdriver to tighten screw 3h to fasten drip rail 3b to printhead 2 .
11. Start the printer up.
For more details about printer startup see “4.1. Starting the Printer up” .