EBS EBS 2600, User Manual

Page: 34 / 184

34 of 184
EN
EBS‑2600 User Man
ual
G2023/04/26_1EN 2023.05.16
Dedicated stands
Section “2.3. Installing the Printer” shows an example of how to install the
printer on a factory conveyor. In fact, the printer can be installed in many ways, also by means of
dedicated stands such as:
– a legged stand (Part No. P910214 ; see Fig. 25 ),
– a wheel stand (Part No. P910208 ; see Fig. 26 ).
Fig. 25.
Fig. 26.
NOTE: The system must be checked for stability!
The stability of the system where the printer is installed using the stands shown in Fig. 25 and Fig. 26
has been tested in the worst foreseeable scenario. However, due to the fact that the printer can be
configured in many ways, it is required that system stability be confirmed each time the installation
is complete. The stand with the printer fastened to it must not tilt or overturn.
The stand with the printer fastened to it should be secured against shifting. If the printer is installed
on a wheel stand, the brakes at the stand wheels must be put on.
The use of stands other than the dedicated ones depicted in
Fig. 25 and Fig. 26 does not guarantee
required stability of the system, which may lead to personal injuries when the stand with the printer
on it tilts or overturns.