Eaton IQ 150S, User & Installation Manual

Page: 32 / 234

IM02601006E www.eaton.com 3-6
IQ 150S/250S 3: Mechanical Installation
3.3: Secure the Cover
1. Close the cover, making sure that power and communications wires exit the submeter through
the openings at the base (see Figure 3.6).
CAUTION!
To avoid damaging components on the board assembly, make sure the front cover
support is in the upright position before closing the front cover.
2. Using the 3 enclosed screws, secure the cover to the base in three places - DO NOT over-
tighten (you may damage the cover). Maximum recommended torque is
0.5/0.6 Nm (4.42/5.31 lbF in).
3. The unit can be sealed after the front cover is closed. To seal the unit, thread a seal tag (not
supplied by Eaton) through the housing located between the bottom access holes (see figures
3.6 and 3.7).
4. Reattach the antenna, if applicable.
Figure 3.7: Submeter with Closed Cover
Closed
Lockable Revenue Seal
Screw