Eaton IQ 150S, User & Installation Manual

Page: 129 / 234

IM02601006E www.eaton.com 6-13
IQ 150S/250S 6: Ethernet Configuration
6.4: Network Module Hardware Initialization
If you don't know your current Network Module settings, or if the settings are lost, you can use this
method to initialize the hardware with known settings you can then work with.
Main Board
1. Place a shorting block on JP3 and press the
Reset
button on the main board.
NOTE:
JP3 is located on the right hand side, upper corner of the main board. The
shorting block can be "borrowed" from JP2, located at the middle, right hand side. See the fig-
ure shown above.
2. After you press the
Reset
button, move the jumper back to JP2.
3. Make sure your settings are the same as those in Section 6.2.1. Follow the steps in Section 6.3
to configure the Network Module.
4 1
3 1
3 1
8
7
8
7
8
7
WD
s e i r t s u d n I o r t c e l E
h c e T e g u a G /
*0
*0
2ESET"UTTON