Eaton IQ 150S, User & Installation Manual

Page: 126 / 234

IM02601006E www.eaton.com 6-10
IQ 150S/250S 6: Ethernet Configuration
Use serial connector (1=CH1 2=CH2) (1) ? 1
Interface Type (1=RS232 2=RS422/RS485+4-wire 3=RS485+2-wire) (1) ? 1
Enter serial parameters (57600,8,N,1) 57600, 8, N, 1
Modem/Configurable Pin Settings (3) (Make sure these settings match those shown in Sec-
tion 6.2.1.)
CAUTION!
You must configure this setting correctly in order to be able to use the Network Module
Hardware Initialization procedure (Section 6.4).
Press 3. The following appears on the screen:
CP0 Function (hit space to toggle) GPIO (In)
Press the Space bar until the following appears on the screen:
CP0 Function (hit space to toggle) Defaults(In)
Press
Enter
. The following appears on the screen:
Invert (active low) (Y) ?
Press
Y
.
Ignore other settings (press
Enter
through the rest of Setting 3).
Advanced Modbus Protocol settings (4) (Make sure these settings match those shown in
Section 6.2.1.)
Slave address (0 for auto, or 1..255 fixed otherwise) (0) ? 0
Allow Modbus Broadcasts (1=Yes 2=No) (2) ? 2
Use MB/TCP 00BH/00AH Exception Responses (1=No 2=Yes) (2) ? 2
Disable Modbus/TCP pipeline (1=No 2=Yes) (1) ? 1
Character Timeout (0 for auto, or 10-6950 msec) (50) 50
Message Timeout (200-65000 msec) (5000) 5000
Serial TX delay after RX (0-1275 msec) (0) 0