Eaton IQ 150S, User & Installation Manual

Page: 186 / 234

IQ 150S
B: Modbus Map
IM02601006E www.eaton.com MM-4
Description
1
Format Range
6
Units or
Resolution Comments
#
Reg
Modbus Address
Hex Decimal
0FA3 - 0FA3 4004 - 4004 Reserved 1
0FA4 - 0FA4 4005 - 4005 Reserved 1
0FA5 - 0FA5 4006 - 4006 Reserved 1
0FA6 - 0FA6 4007 - 4007 Reserved 1
0FA7 - 0FA7 4008 - 4008 Reserved 1
0FA8 - 0FA8 4009 - 4009 Reserved 1
0FA9 - 0FA9 4010 - 4010 Reserved 1
0FAA - 0FAA 4011 - 4011 Reserved 1
0FAB - 0FAB 4012 - 4012 Reserved 1
0FAC - 0FAC 4013 - 4013 Reserved 1
0FAD - 0FAD 4014 - 4014 Reserved 1
0FAE - 0FAE 4015 - 4015 Reserved 1
0FAF - 0FAF 4016 - 4016 Reserved 1
0FB0 - 0FB0 4017 - 4017 Reserved 1
0FB1 - 0FB8 4018 - 4025 Reserved 8
0FB9 - 0FBC 4026 - 4029 Reserved 4
0FBD - 0FC4 4030 - 4037 Reserved 8
0FC5 - 0FC8 4038 - 4041 Reserved 4
Block Size: 42
read-only
1003 - 1003 4100 - 4100 Phase A Current SINT16 -1800 to +1800 0.1 degree 1
1004 - 1004 4101 - 4101 Phase B Current SINT16 -1800 to +1800 0.1 degree 1
1005 - 1005 4102 - 4102 Phase C Current SINT16 -1800 to +1800 0.1 degree 1
1006 - 1006 4103 - 4103 Angle, Volts A-B SINT16 -1800 to +1800 0.1 degree 1
1007 - 1007 4104 - 4104 Angle, Volts B-C SINT16 -1800 to +1800 0.1 degree 1
1008 - 1008 4105 - 4105 Angle, Volts C-A SINT16 -1800 to +1800 0.1 degree 1
Block Size:
6
read-only
1387 - 1387 5000 - 5000 Meter Status UINT16 bit-mapped --exnpch ssssssss exnpch = EEPROM block OK flags
(e=energy, x=max, n=min, p=programmable
settings, c=calibration, h=header),
ssssssss = state (1=Run, 2=Limp, 10=Prog
Set Update via buttons, 12=Prog Set
Update via COM2) 1
1388 - 1388 5001 - 5001 Reserved 1
1389 - 138A 5002 - 5003 Time Since Reset UINT32 0 to 4294967294 4 msec
wraps around after max coun
2
Block Size:
4
Status Block
Phase Angle Block
14