Eaton IQ 150S, User & Installation Manual

Page: 136 / 234

IM02601006E www.eaton.com 7-6
IQ 150S/250S 7: Using the Submeter
7.2.4: Entering a Password
If Password protection has been enabled in the software for reset and/or configuration (see
Chapter 5 for more information), a screen appears requesting a password when you try to reset
the meter and/or configure settings through the front panel.
• PASS appears in the A window and 4 dashes appear in the B window. The leftmost dash is
flashing.
1. Press the
Down
button to scroll numbers from 0 to 9 for the flashing dash. When the correct
number appears for that dash, use the
Right
button to move to the next dash.
Example
: The left screen, below, shows four dashes. The right screen shows the display after the
first two digits of the password have been entered.
2. When all 4 digits of the password have been selected, press the
Enter
button.
• If you are in Reset Mode and you enter the correct password, “rSt dMd donE” or “rSt EnEr
donE”appears and the screen resumes auto-scrolling parameters.
• If you are in Configuration Mode and you enter the correct password, the display returns to
the screen that required a password.
• If you enter an incorrect password, “PASS ---- FAIL” appears and:
• The previous screen is re-displayed, if you are in Reset
Mode.
• The previous Operating mode screen is re-displayed, if
you are in Configuration mode.
A
B
C
-
-
-
MENU ENTER
A
B
C
-
-
-
MENU ENTER
PASS
12__
A
B
C
-
-
-
MENU ENTER