Eaton IQ 150S, User & Installation Manual

Page: 118 / 234

IM02601006E www.eaton.com 6-2
IQ 150S/250S 6: Ethernet Configuration
6.2.1: Modbus/TCP to RTU Bridge Setup
1) Network/IP Settings:
Network Mode…………Wired Only
IP Address .............10.0.0.1
Default Gateway .....--- not set ---
Netmask ...............255.255.255.0
2) Serial & Mode Settings:
Protocol ................Modbus/RTU,Slave(s) attached
Serial Interface ..... 57600,8,N,1,RS232,CH1
3) Modem/Configurable Pin Settings:
CP0..! Defaults (In) CP1..! GPIO (In) CP2..! GPIO (In)
CP3..! GPIO (In) CP4..! GPIO (In) CP5..! GPIO (In)
CP6..! GPIO (In) CP7..! GPIO (In) CP8..! GPIO (In)
CP9..! GPIO (In) CP10.! GPIO (In)
RTS Output ......... Fixed High/Active
4) Advanced Modbus Protocol settings:
Slave Addr/Unit Id Source .. Modbus/TCP header
Modbus Serial Broadcasts ...Disabled (Id=0 auto-mapped to 1)
MB/TCP Exception Codes ....Yes (return 00AH and 00BH)
Char, Message Timeout ...... 00050msec, 05000msec
6) WLAN Settings:
WLAN ............... Disabled, network:LTRX_IBSS
Topology……………. AdHoc, Country: US, Channel: 11