Eaton IQ 150S, User & Installation Manual

Page: 117 / 234

IM02601006E www.eaton.com 6-1
IQ 150S/250S 6: Ethernet Configuration
6: Ethernet Configuration
6.1: Introduction
The IQ 150S/250S submeter has an option for a WiFi (Wireless) or RJ45 Ethernet connection.
This option allows the submeter to be set up for use in a LAN (Local Area Network), using stan-
dard WiFi base stations. Configuration for these connections is easily accomplished through your
PC using Telnet connections. Then you can access the submeter to perform meter functions
directly through any computer on your LAN: the IQ 150S/250S meter does not need to be directly
connected (wired) to these computers for it to be accessed.
This chapter outlines the procedures you use to set up the IQ 150S/250S submeter to function via
its Ethernet configuration.
6.2: Factory Default Settings
The settings shown in Section 6.2.1 are the default settings for the IQ 150S/250S submeter: they
are the settings programmed into your meter when it is shipped to you. You may need to modify
some of these settings when you set up your Ethernet configuration.
NOTES:
• Change Settings 1 and 6 ONLY. Settings 2, 3, and 4 must be the same as shown in Section
6.2.1. If they are not, reset them to the values shown in Section 6.2.1.
• If setting 3 is not CP0..! Defaults (In), the procedure for Network Module Hardware Initialization
(Section 6.3.4) will not work.