Eaton IQ 150S, User & Installation Manual

Page: 191 / 234

IQ 150S
B: Modbus Map
IM02601006E www.eaton.com MM-9
(continued)
6
7
8
9
10
11
12
13
14
15
Not used.
All 3 voltage angles are measured for Wye and Delta hookups. For 2.5 Element, Vac is measured and Vab & Vbc are calculated. If a voltage phase is missing, the two voltage angles in which it
participates are set to zero. A and C phase current angles are measured for all hookups. B phase current angle is measured for Wye and is zero for other hookups. If a voltage phase is missing, its cu
angle is zero.
If any register in the programmable settings section is set to a value other than the acceptable value then the meter will stay in LIMP mode. Please read the comments section or the range for each register
in programmable settings section for acceptable values.
Not used.
Energy registers should be reset after a format change.
Reset commands make no sense if the meter state is LIMP. An illegal function exception will be returned.
Not used.
M denotes a 1,000,000 multiplier.
Not used.
Writing this register causes data to be saved permanently in EEPROM. If there is an error while saving, a slave device failure exception is returned and programmable settings mode automatically
terminates via reset.