Eaton IQ 150S, User & Installation Manual

Page: 12 / 234

IM02601006E www.eaton.com 1-2
IQ 150S/250S 1: Introduction
Safety Precautions
All safety codes, safety standards, and/or regulations must be strictly observed in the installation,
operation, and maintenance of this device.
WARNINGS refer to instructions that, if not followed, can result in death or injury.
CAUTIONS refer to instructions that, if not followed, can result in equipment dam-
age.
WARNINGS
SHOCK HAZARDS:
IMPROPER INSTALLATION CAN CAUSE DEATH, INJURY, AND/OR EQUIP-
MENT DAMAGE.
Follow all Warnings and Cautions. Completely read and understood the information in this docu-
ment before attempting to install or operate the equipment. Improper wiring could cause death,
injury, or equipment damage. Only qualified personnel are to service the IQ 150S/250S Meter.
TROUBLESHOOTING PROCEDURES MAY REQUIRE PROXIMITY TO EXPOSED ENER-
GIZED(LIVE) ELECTRICAL WIRING AND/OR PARTS WHERE THE HAZARD OF FATAL ELEC-
TRIC SHOCK IS PRESENT. Exercise extreme care to avoid injury or death. Always disconnect,
lock-out, and tag the current and voltage sources and the control power supply circuit before
touching the connections or components on the rear face of the meter base unit.
FAILURE TO GROUND THE IQ 150S/250S METER MAY RESULT IN INJURY, DEATH, OR
EQUIPMENT DAMAGE. Properly ground the IQ 150S/250S Meter during installation.
FCC Information
Regarding the wireless module:
• This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: 1) this device may not cause harmful interference, and 2) this device must accept
any interference received, including interference that may cause undesired operation.
• The antenna provided must not be replaced with an different type. Attaching a different antenna
will void the FCC approval and the FCC ID can no longer be considered.