DTM Print CX86e, User Manual, Page: 82 / 214

82
Supported
Paper Type Sensor Position
Printer Driver or Operation Panel Setting*
PAPER FORM CUT TYPE
Cut Sheet Top: Position that does not overlap
with the bottom sensor
Bottom: Center
CUT PAPER -
*The setting of the printer driver is prioritized.
Adjusting the Paper Sensor Position
If the guide ribs are attached, remove them before adjusting the position of the paper sensors. When the adjustment
is complete, attach them again.
For information on attaching the guide ribs, refer to “Attaching the Guide Ribs.”
Insert your finger below the gray lever on the left of the machine rear, and lift it up to open the feeder cover.
Insert a stick-shaped thing with a pointing tip (such as a small flat head screwdriver) into the back of the metal part of
the upper sensor on the back of the feeder cover, and pull it out to unlock it.