DTM Print CX86e, User Manual

Page: 184 / 214

184
Click [Next] on the [IP Traffic Destination] screen.
Click [Next] on the [IP Protocol Type] screen.
Click [Complete].
—
Setting the Filter Operations
Click [OK] in the [IP Filter List] window.
In [Security Rules Wizard], select the new IP filter in the list, and click [Next].
Click [Add] on the [Filter Action] screen.
Click [Next] in [Filter Action Wizard].
On the [Filter Action Name] screen, enter [Name] and [Description], and click [Next].
On the [Filter Action General Options] screen, select [Negotiate security], and click [Next].
On the [Communicating with computers that do not support IPsec] screen, select [Do not allow unsecured communi-
cation], and click [Next].
On the [IP Traffic Security] screen, select [Custom], and click [Setup].
Configure the settings in the [Custom Security Method Settings] window, and click [OK].
—
Specify the same values as specified in [ESP Encryption Algorithm], [ESP Authentication Algorithm], [AH Authenti-
cation Algorithm], and [Lifetime] in “Phase2 Proposal” in “Configuring the Machine.”
Click [Next] on the [IP Traffic Security] screen.
Select [Edit Properties], and click [Complete].
—
Assigning an IP Security Policy
To enable key PFS, select [Use session key perfect forward secrecy (PFS)] in the [Filter Action Properties] window.
To perform IPSec communication with an IPv6 global address, select [Accept unsecured communication, but always
respond using IPsec].
Click [OK].
Select the new filter operation, and click [Next].
On the [Authentication Method] screen, select the authentication method, and click [Next].
—
If an advance shared key was set in “Configuring the Machine,” enable “Use this string to protect the key exchange