DTM Print CX86e, User Manual

Page: 79 / 214

79
Cut Type
Set the type of mark used for cutting the paper. Set it according to the paper to use.
When the paper has a black mark on the surface that is printed on: B/M(FRONT)
When the paper has a black mark on the surface that is not printed on: B/M(BACK)
For paper with a hole in the center: CENTER HOLE
For paper without a hole in the center: SIDE HOLE
For label stock with GAP set to: CENTER HOLE
For paper without a mark: LENGTH
—
Press ∨ button once to display [CUT TYPE], and press «OK» button.
—
With the setting flashing, press
∧
button or
∨
button to display the value you want to set, and press «OK» but-
ton.
—
Confirm that the setting stops flashing and "*" is displayed to the right of the value you want to set.
—
If you set [LENGTH], proceed to step 23.
If you set something other than [LENGTH], proceed to step 20.
Cut Position
This setting specifies the cut position of paper with a black mark or hole.
When set to 0 mm, the paper is cut at the center of the black mark or hole.
The values that can be set are indicated below.
Paper with a black mark: -6.5 mm (-0.25 inches) to the paper length
Paper with a hole: -6.5 mm to 6.5 mm (-0.25 inches to 0.25 inches)
Generally set this to 0 mm when printing on paper with a hole. If the paper cannot be cut in the center of the
hole, change the setting.
—
Press ∨ button twice to display [CUT POSITION SET], and press «OK» button.
—
With the setting flashing, press ∧ button or ∨ button to display the value you want to set, and press «OK» but-
ton.
—
Confirm that "*" is displayed to the right of the value you want to set.
—
Press «ONLINE» button, or press «BACK» button until "READY TO PRINT" is displayed.