Understanding the System Menus
|
97
❚
Admin Settings > Network >
Advanced Settings >
PS Data Format
Specifies PostScript 3 Compatible communication protocol for a parallel interface, you
can configure the
PS Data Format
settings for the wired network. The change
becomes effective after the printer is turned off and then on again.
❚
Admin Settings >
Network >
Reset LAN
Initializes wired network data stored in non-volatile memory (NVM). After executing this
setting and restarting the printer, all wired network settings are reset to their default
values.
❚
Admin Settings >
Network >
Delete All Certificates
Deletes all certificates of the printer. After executing this setting and restarting the
printer, all certificates are deleted.
❚
Admin Settings >
Fax Settings
Use the
Fax Settings
menu to configure the basic fax settings.
❚
Admin Settings >
Fax Settings >
Fax Line Settings
Configures basic settings for the fax line.
❚
Admin Settings > Fax Settings >
Fax Line Settings >
Fax Number
Sets the fax number of the printer to be printed on the header of a fax message.
NOTE:
•
Make sure to specify
Fax Number
before using
Junk Fax Setup
.
❚
Admin Settings > Fax Settings >
Fax Line Settings >
Country
Selects the country where the printer is used.
❚
Admin Settings > Fax Settings >
Fax Line Settings >
Fax Header Name
Sets the sender name to be printed on the header on faxes.
Auto
Used when auto-detecting the PostScript 3 Compatible
communication protocol.
Standard
Used when the communication protocol is in ASCII interface.
BCP
Used when the communication protocol is in binary format.
TBCP
Used when the communication protocol supports both ASCII and
binary data to switch between them according to the specified
control code.
Binary
Used when no special processing is required for data.
Summary of Contents for H625cdw
Page 329: ... 329 6 Maintaining Your Printer ...
Page 353: ... 353 7 Troubleshooting ...
Page 394: ...394 Appendix ...