Getting Started
Using IVR on the Cisco SPA 501G IP Phone
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide
18
1
221
Set call control—enter the value for the call control method you want,
then press #:
•
0: SIP
•
1: SPCP
To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *.
73738
Restore the phone to the factory default software and settings.
Enter 1 to confirm, or * to exit. If you chose to reset, hang up to exit and
begin the restore process.
87778
Restore the phone’s user settings to the default. (Clears all user settings
such as speed dials.)
Enter 1 to confirm, or * to exit. If you chose to reset, hang up to exit and
begin the restore process.
732668
Reboot the phone. After entering #, hang up to begin rebooting.
111
Set a static IP address. Enter the address (use * to enter the “.” value),
then press #.
To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *.
NOTE
DHCP must be disabled to use this option; if DHCP is not
disabled, you receive an error message.
121
Set a netmask. Enter the address (use * to enter the “.” value), then
press #.
To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *.
NOTE
DHCP must be disabled to use this option; if DHCP is not
disabled, you receive an error message.
131
Set a gateway. Enter the address (use * to enter the “.” value), then
press #.
To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *.
NOTE
DHCP must be disabled to use this option; if DHCP is not
disabled, you receive an error message.
161
Set the address of the primary Domain Name Server (DNS). Enter the
address (use * to enter the “.” value), then press #.
To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *.
Number
Option
