Provisioning Basics
Provisioning Capabilities
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide
135
6
To provision from the phone:
SPA 50XG:
STEP 1
Press Setup, then scroll to Profile Rule.
STEP 2
Enter the profile rule using the following format, then press the Resync soft button.
protocol
://
server[:port]/profile_pathname
For example:
tftp://192.168.1.5/spa504.cfg
If no protocol is specified, TFTP is assumed. If no server-name is specified, the
host that requests the URL is used as
server-name
.
If no port is specified, the default port is used (69 for TFTP, 80 for HTTP, and 443
for HTTPS). then the address can be entered in and press
Resync
.
The status of the remote customization process is shown by the phone’s mute
button blinking in the following patterns:
•
Red/orange slow blink (1.0 seconds on, 1.0 seconds off): Contacting server,
server not resolvable, not reachable, or down
•
Red/orange slow blink (0.2 seconds on, 0.2 seconds off, 0.2 seconds on, 1.4
seconds off): Server responded with file not found or corrupt file
WIP310
STEP 1
Press the
Select
button to choose
Settings
and press the
Select
button again.
STEP 2
Navigate to
Misc Settings
.
STEP 3
Navigate to profile rule. Enter the profile rule in the following format:
protocol
://
server[:port]/profile_pathname
For example, to have the WIP310 provisioning done by the Cisco SPA 9000
Voice System, enter:
192.168.2.64/cfg/generic.xml
