Canon ImageRunner iR8500 Series, Service Manual, Page: 993 / 1122

Chapter 17
17-149
BASE-SW Switching from the MEAP-Full mode to the Base model
1
<Setting value>
0: OFF (Base model), 1: ON (Full model)
SC-L-CNT switches the thresh value for the scan counter (large/small).
Setting value: 0 (B4 as threshold) or 1 (LTR as threshold)
default: 0
1
IDL-MODE Use it to select idle rotation mode for the developing assembly.
2
MEMO:
Set it to '2' or '3' if the image becomes distorted or too light.
<Setting value>
0: OFF (no idle rotation)
1: auto control based on readings of environment sensor (default)
2: start idle rotation when fixing roller temperature reaches 100 deg C
3: start idle rotation when main power switch goes ON
SCANSLCT Turning ON or OFF the function of calculating a scan area from the selected
paper size
2
<Setting value>
0: OFF (Determining the scan area by document detection)
1: ON (Determining the scan area by paper size)
OHP-TEMP Use it to switch among temperature settings for transparency mode.
2
MEMO:
The fixing temperature will be lowered to improve separation of
transparencies from the fixing roller.
<Setting value>
0: 198 deg C (default)
1: 193 deg C
2: 188 deg C
3: 183 deg C
OHP-CNT Use it to turn ON/OFF the potential control mechanism for transparency
mode.
2
<Setting value>
0: use target value obtained in potential control of transparency mode
(default)
1: do not use potential control in transparency mode
FIX-TMP1 Use it to select a temperature for starting down-sequence for plain paper.
2
MEMO:
If the user wants priority on image quality, set it to '0'; on speed, set it to '2'.
<Setting value>
0: 183 deg C
1: 178 deg C (default)
2: 173 deg C
TRSW-P-B Use it to turn ON/OFF the transfer current output correction mechanism at the
trailing edge of paper.
2
<Setting value>
0: ON
1: OFF (default)
SP-MODE Use it to turn ON/OFF the separation current output correction mechanism.
2
<Setting value>
0: standard mode (default)
1: low voltage mode
FTMP-DWN USE it to select enhanced stacking mode.
2
MEMO:
The fixing temperature is lowered to enhance stacking in the finisher.
<Setting value>
0: OFF (default)
1: decrease by -5 deg C
2: decrease by -10 deg C
3: decrease by -15 deg C
COPIER > OPTION > BODY
Sub-item Description Level