Canon ImageRunner iR8500 Series, Service Manual, Page: 110 / 1122

Chapter 2
2-8
F-2-18
Outline of the Work Space
Use the following as a guide when considering space for service work:
- Main body + Finisher
F-2-19
- Main body + Fi Side Paper Deck
F-2-20
2.1.5 Points to Note Before Starting the Work
0007-6374
iR105i/iR105+ / iR9070
Go through the following before starting to install the machine:
1) If the machine is moved from a cold to warm place, it can develop condensation in the form of droplets of water on its metal surfaces.
Use of the machine while it suffers from condensation can lead to image faults.
If the machine has been moved from a cold to warm place, be sure to leave it for 1 hour or more without unpacking so that it becomes fully used to the
new place.
2) If stairs are used to move the machine into or out of the site of installation, keep the following in mind:
a.Take out the ADF, fixing/feeding assembly, holding tray assembly, and copy paper, and carry them separately from the main body.
b.When lifting the machine, do not use the grips on the pickup assembly/ delivery assembly. Instead, be sure to support the machine at four corners of its
bottom.
3) Shift up the 2 adjusters (front) found on the bottom of the machine to be sure that they are unlocked. The adjusters can slip out of the bottom of the
machine because of vibration during transportation. Take care not to loose them.
4) Be sure to work as a group of three or more. When removing the pad, in particular, one must hold the rear grip and one the front grip, while the other
removes the pad.
5) Be sure to remove the accessories (side paper deck, finisher, paper folding unit) when moving the machine into or out of the site of installation to prevent
damage.
2.1.6 Points to Note Before Starting the Work
0007-1499
/ iR8070
Wrong 2
250 cm min.
120 cm min.
10 cm min.
50 cm min.
Main
body
200 cm min.
50 cm min.
310 cm min.
120 cm min.
10 cm min.
110 cm min.
Main
body
200 cm min.
50 cm min.