Canon ImageRunner iR8500 Series, Service Manual, Page: 992 / 1122

Chapter 17
17-148
FUZZY Use it to turn on/off fuzzy control and to make environment settings.
1
MEMO:
- The selection will affect pre-transfer, transfer, and separation charging
currents.
- Selecting 1 through 3 will make the operation independent of the envi-
ronment sensor.
<Setting value>
0: fuzzy control ON (default),
1: low humidity environment mode (current level lower than standard),
2: normal humidity environment mode,
3: high humidity environment mode (current level higher than standard)
CNT-W/PR Use it to turn ON/OFF the mechanism to change density during printing (PDL
input).
1
<Setting value>
0: correct target value to enable change of density during printing (default)
1: do not change density during printing
CONFIG Selecting several types of firmware installed on the hard disk and switching
the country, language, and paper size type of this machine
1
<Adjustment method>
XXYYZZAAXX: Country (UP), YY: Language (ja), ZZ (00) Destination
(00:CANON 01:OEM), AA (00): Paper size type (00:AB 01:Inch 02:A
03:All size)
<Operating procedure>
1) Select <CONFIG>.
2) Select an item to reverse its display. Then press the + or - key to change the
contents.
3) Each time the + or - key is pressed, the contents change sequentially.
4) Display the intended contents at all items and press the OK key.
5) Turn the main power switch OFF and ON.
TR-SP-C1 Use it to set the transfer/separation output setting when the right deck is
selected, thereby preventing faults otherwise occurring.
1
<Setting value>
0: setting for plain paper (default)
1: setting for recycled paper
2: setting for tracing paper
TR-SP-C2 Use it to set the transfer/separation output setting when the left deck is used,
thereby preventing faults otherwise occurring.
1
<Setting value>
0: setting for plain paper (default)
1: setting for recycled paper
2: setting for tracing paper
TR-SP-C3 Use it to set the transfer/separation output setting when the cassette 3 is used,
thereby preventing faults otherwise occurring.
1
<Setting value>
0: setting for plain paper (default)
1: setting for recycled paper
2: setting for tracing paper
TR-SP-C4 Use it to set the transfer/separation output setting when the cassette 4 is used,
thereby preventing faults otherwise occurring.
1
<Setting value>
0: setting for plain paper (default)
1: setting for recycled paper
2: setting for tracing paper
TR-SP-MF Use it to set the transfer/separation output setting when the manual feed tray
is used, thereby preventing faults otherwise occurring.
1
<Setting value>
0: setting for plain paper (default)
1: setting for recycled paper
2: setting for tracing paper
TR-SP-DK Use it to set the transfer/separation output setting when the side paper deck is
used.
1
<Setting value>
0: setting for plain power (default)
1: setting for recycled paper
2: setting for tracing paper
DEV-SLOW Use it to set the speed of the developing sleeve.
1
<Setting value>
0: in relation to environment
1: fixed to high speed
2: fixed to low speed (default)
STPL-SFT Use it to specify where to execute shift stacking in staple mode.
1
<Setting value>
0: perform shift stacking in staple mode (as it is: default)
1: do not perform shift stacking in staple mode
COPIER > OPTION > BODY
Sub-item Description Level