Canon ImageRunner iR8500 Series, Service Manual, Page: 1036 / 1122

Chapter 17
17-192
IDPRN-SW switches over count job types of the group control counter.
0:increases the count for the PRINT category (Box print, Report print, SendLocal
print, PDL print (default)).
1:increase the count for the COPY category (COPY).
1:increases the count for the PRINT category (Report print, SendLocal print,
PDL print)
0:increases the count for the COPY category (COPY, Box print)
1
CNT-SW Switching the charging counter and default display items
1
<Setting value>
- When the set value is 0 [Default]
101: Total 1
- When the set value is 1
102: Total 2
202: Copy total 2
127: Total A2
- When the set value is 2
101: Total 1
104: Total small
103: Total large
501: Scan total 1
TAB-ACC Set the tab paper (index paper) and the setting tab paper (index paper) if ACC is
available.
1
<Setting value>
0: ACC is not available between tab papers (Default)
1: ACC is available between tab papers
FRM-RPT Use it to specify a margin in image repeat mode:
1
<Setting value>
0: erform image repeat without margin
1: erform image repeat with margin
BCNT-AST Switching the job type of counting box prints by ASSIST
1
<Setting value>
0: Count as PDL job [Default]
1: Count as Copy job
DOC-REM turns on or off the message indicated to prompt removal of originals.
After an original has been read in copyboard mode, an attempt to start reading
with an original in the feeder without opening and then closing the feeder will
cause the machine to indicate a message promoting the removal of the original.
Use this switch to enable or disable the message.
<Setting value>: 0 (do not indicate) or 1 (indicate)
<Setting value>: 0
1
TRAY-SEL delivery tray position switch (Finisher-K1)
1
Use it to switch over the target of output when the following settings are made:
multiple originals, copy count at 1, sort mode, special tray A & B.
0: use sample tray for output
1: use tray B for output
SIZE-DET Turning the document size detection function ON or OFF
2
<Setting value>
0: OFF (When the platen is opened, the user will not be dazzled because the lamp
does not light.)
1: ON [Default]
DATE-DSP Switching the date display format
2
<Setting value>
0: YY/MM/DD
1: DD/MM/YY
2: MM/DD/YY
MB-CCV Limiting the mailbox control card user
2
<Setting value>
0: No [Default]
1: Yes
PR-D-SEL Use it to set the density of printing (PDL input).
2
<Setting value>
0 to 8 (4: default)
0 (light) <=> 4 (standard) <=> 8 (dark)
TRY-STP Setting output or no output in the tray full state
2
<Setting value>
0: Ordinary mode (Interrupt when the finisher tray is full) [Default]
1: Interrupt by height detection only
MF-LG-ST Setting the long mode key
2
<Setting value>
0: Ordinary [Default]
1: Display a long mode key on the corresponding mode screen
COPIER > OPTION >USER
Sub-item Description Level