Canon ImageRunner iR8500 Series, Service Manual, Page: 1017 / 1122

Chapter 17
17-173
COUNTER2to6 Setting Software counters 2 to 6 on the User mode screen
1
<Setting value>
0 to 999
CONTROL Limiting the user of a control card for a PDL job
1
<Setting value>
0: Do not use [Default]
1: Use
B4-L-CNT Setting whether to count B4 as the large size or the small size on Software
counters 1 to 6
1
<Setting value>
0: Small size [Default]
1: Large size
TAB-ROT If the image is a PDL landscape in PDL, use it to specify whether to rotate it 180
deg.
1
<Setting value>
0: do not rotate [Default]
1: rotate
PR-PSESW Setting whether or not to display the print pause function switch
1
<Setting value>
0: No print pause function [Default]
The user screen does not display the print pause function. (Conventional
specification)
1: Print pause function [Default]
The user screen does not display the print output stop and restart settings.
IDPRN-SW switches over count job types of the group control counter.
1
0: increases the count for the PRINT category (Box print, Report print,
SendLocal print, PDL print (default)).
increase the count for the COPY category (COPY).
1: increases the count for the PRINT category (Report print, SendLocal print,
PDL print)
increases the count for the COPY category (COPY, Box print)
CNT-SW Switching the charging counter and default display items
1
<Setting value>
- When the set value is 0 [Default]
101: Total 1
- When the set value is 1
102: Total 2
202: Copy total 2
127: Total A2
- When the set value is 2
101: Total 1
104: Total small
103: Total large
501: Scan total 1
TAB-ACC Set the tab paper (index paper) and the setting tab paper (index paper) if ACC is
available.
1
<Setting value>
0: ACC is not available between tab papers (Default: 0)
1: ACC is available between tab papers
BCNT-AST Switching the job type of counting box prints by ASSIST
1
<Setting value>
0: Count as PDL job [Default]
1: Count as Copy job
DOC-REM turns on or off the message indicated to prompt removal of originals.
1
After an original has been read in copyboard mode, an attempt to start reading
with an original in the feeder without opening and then closing the feeder will
cause the machine to indicate a message promoting the removal of the original.
Use this switch to enable or disable the message.
<Setting value>
0 (do not indicate) or 1 (indicate)
<Setting value>
0
TRAY-SEL delivery tray position switch (Finisher-K1)
1
Use it to switch over the target of output when the following settings are made:
multiple originals, copy count at 1, sort mode, special tray A & B.
0: use sample tray for output [Default]
1: use tray B for output
DATE-DSP Switching the date display format
2
<Setting value>
0: YYMM/DD [Default]
1: DD/MM/YY
2: MM/DD/YY
COPIER > OPTION >USER
Sub-item Description Level