Canon ImageRunner iR8500 Series, Service Manual, Page: 126 / 1122

Chapter 2
2-24
1) Remove the packing tape from the copier.
2) Open the ADF.
Remove the copyboard glass protective padding.
3) Remove the tape [1], and slide the scanner fixing [2] toward the front
to detach
(Store away the fixing screw for possible relocation of the machine in
the future).
F-2-76
2.2.10 Mounting the Charging Assembly
0007-6622
iR105i/iR105+ / iR9070
1) Remove the screw [2], and detach the transfer/separation assembly
front cover [1].
F-2-77
2) Remove the fixing [1] (1 screw [2]), and disconnect the connector [3].
F-2-78
3) While holding down the front and rear of the transfer/separation
charging assembly [1], pull it by 1 cm toward the front; then, detach
it toward the upper left.
Using alcohol, clean the transfer/ separation charging wire.
F-2-79
4) While keeping the following in mind, mount the transfer/separation
charging assembly:
- The solvent must completely be dry.
- The gut wire must not be brought into contact with the transfer guide
[1] to avoid a cut.
- The grounding plate [2] must be on the outside of the charging
assembly frame [3] (See the figure).
F-2-80
F-2-81
5) Connect the connector of the transfer/ separation charging assembly,
and mount the fixing.
6) Using a screw, mount the toner/separation charging assembly front
cover.
Push in the fixing/feeding assembly inside the machine, and shift the
fixing/feeding assembly releasing lever [1] back into position.
F-2-82
[2]
[1]
[2]
[1]
[3]
[1]
[2]
[1]
[1]
[3]
[2]
[1]