Cabletron Systems MMAC-Plus 9F116-01, User Manual, Page: 392 / 420

E-4 FRX/FRM 3. 3 User G uide, Rev 04
Vary Commands
VARY ACT
Function: Changes the desired status of specified PUs to an active state.
Command:
V NET,ACT, ID={linename[,A|U|C],puname}
Options:
A
= activate all PUs on the line.
U
= activate all PUs on the line whose
ISTATUS = ACTIVE
.
C
= activate all PUs except those that have never been activated
(
NEVAC
). Of those, activate all whose
ISTATUS = ACTIVE
.
VARY INACT
Function: Changes the desired status of specified PUs to an inactive state.
Command:
V NET,INACT, ID={linename[,I|R|F],puname}
Options:
I
= de-activate all PUs on the line immediately.
R
= de-activate, then re-activate, all PUs on the line immediately.
F
= reset all PUs on the line to an inactive state. If appropriate, a
de-activate command will be sent.
Modify Commands
MODIFY CONFIG
Function: Modifies one or more configuration parameters for a specified PU, or
for a specified line if a PU is not specified. There are two MODIFY
CONFIG commands:
F NET, CONFIG,ID=“nnnn” will update the System Memory value(s)
in the FRX/FRM record for the SNA Port or LLC2 Host
(depending on the parameter). The changes will be in effect until an
on-line database update or re-IPL of the node is performed, or an
F NET, CONFIG,COMMIT (see below) is sent.
F NET, CONFIG[,COMMIT] will update the FRX/FRM record’s
Database value(s) with all changes made since the last COMMIT ,
on-line update of the record, or node IPL.
Command: F NET, CONFIG,ID={linename[,keyword=value],puname
[,keyword=value]}
Keywords when the line is being modified are listed below. If two
words are shown, either can be used. The parameters are described in
Chapter 8.