Cabletron Systems MMAC-Plus 9F116-01, User Manual, Page: 243 / 420

Configuring IPX 12-15
Destination Subscriber
is a subscriber ID associated with the physical X.25 port that will be used for the IPX
interface. (See the footnote following Table 12-9.)
SVC Retry Timer
is the frequency with which calls will be placed to try to establish a connection.
SVC Idle Timer
is a period that an IPX connection can remain active with no traffic before the con-
nection is cleared.
Max VCs to Establish
specifies a number of virtual circuits over which IPX traffic will be transmitted in par-
allel.
PVC Connection
identifies this interface as one end of a PVC.
1
Make sure the port is not configured (in the Port record) for backup use only. (See
Chapter 5.)
2
Make sure the DLCI is not part of a frame relay DLCI backup group or intra-nodal frame
relay PVC (both described in Chapter 7).
IPXWAN Enabled
determines whether Novell's IPXWAN protocol will be used on the interface.
IPXWAN specifies a method for IPX routers to communicate across WAN links. FRX
and FRM implement IPXWAN running over RFC 1490-compliant frame relay and
RFC1356-compliant X.25.
Source Card/Port/DLCI
identifies the location of this end of the frame relay IPX interface.
Make sure the physical frame relay port is not reserved for
backup DLCIs (as determined by the
For Backup Use Only
parameter in the port record—see Chapter 6).
Also make sure the DLCI is not part of a frame relay DLCI
backup group or frame relay PVC.
Table 12-10 IPX Frame Relay Interface Parameters
Parameter Valid Values Default Value
IPXWAN Enabled Y/ N N
Source Card
FRX4000, FRM: 0
FRX6000: 0–7 0
Source Port 0–7
1
0
Source DLCI 16–991
2
16