Cabletron Systems MMAC-Plus 9F116-01, User Manual, Page: 172 / 420

8-30 FRX/FRM 3. 3 User G uide, Rev 04
Path Cost
will be added together with all other path costs on a link between bridges. The total
will then be compared to other total path costs to determine the least "expensive" end-
to-end path.
Priority
prioritizes intra-nodal traffic; the higher the number, the higher the priority. (This pri-
ority has no effect on traffic exiting a node.)
A priority is also configured in Node Defaults, as well as for each logical port, SNA
PU, LLC2 host, IP interface, IPX interface, SVC subscriber, and PVC connection. The
device processor in the node uses these priorities to help determine the order in which
it will process protocols.
When configuring priorities, be careful to consider the types of
traffic being routed on other connections in the node.
LAN Card
identifies the LAN card in an FRX6000 or FRM, as defined in PROTOCOL.INI (
[A],
[C], [B]
from the Main Menu).
LAN ID
identifies the ring number used by a frame relay-compliant source-route bridge at the
other end of this PVC. The value is normally assigned by a system administrator.
Each LAN ID must be unique within the network on which this
node will operate.
RLP/Port
identifies the RLP and physical port containing the interface.
Make sure the physical frame relay port is not reserved for
backup DLCIs (as determined by the
For Backup Use Only
parameter in the port record—see Chapter 6).
DLCI
matches the connection with an interface at the remote end of the link.
Make sure the DLCI is not part of a frame relay DLCI backup
group or frame relay PVC.
Format
is the RFC1490 encapsulation method used for LLC2 traffic.