Cabletron Systems MMAC-Plus 9F116-01, User Manual, Page: 178 / 420

9-4 FRX/FRM 3. 3 User G uide, Rev 04
1
Relevant only if
Physical Port Interface
is other than
RS-232
and
Generate Clock
is
Y
.
2
See note under Figure 9-1.
Port Type
defines the protocol the port will support. Selecting this parameter will display a list
of valid protocols. An FRX4000 port can be configured as any WAN protocol loaded
in the device. An FRX6000 or FRM port can be configured as any WAN protocol con-
figured on this port's RLP. (Protocol configuration is described in Chapter 4.)
Generate Clock Y/N Y
Rcv Clock (TT) from DTE Y/N
1
N
BSC Type 1
(TPAD),
2
(HPAD)
1
Answer Non-Configured
2
Y/N Y
Activate Connecti on w/o poll
2
Y/N Y
On-line Sys. Memory Changes Y/N N
EBCDIC Y/N Y
Cal l Info in Cal l Request Packet
n/a – leave at default
Y
Clear VC on Last Device Down Y/N N
Tr ansparent Text Supported Y/N N
End-to-End Acknowledgment
n/a – leave at default
N
Full Duplex
n/a – leave at default
Y
Multidrop Y/N N
Sl ow Poll Retr y Count 10–150 20
Sl ow Poll Retr y Frequency 1–200 20
# of Beginning Sync Char 2–10 2
# of Trai ling Pad Characters 1–10 1
Poll Interval Tim er
(msec)
100–1000 500
No Response Ti mer
(sec)
2–10 2
No Response Retr y Count 1–255 5
Er ror Retransmit Count 1–255 5
NAK Retry Count 1–255 5
Block Check A–C
none
Data Mode A–C
none
Sq
(Sequence)
1–16
none
Local Sub 0–15 characters
none
Remote Sub 0–15 characters
none
Atcl
(Autocall)
Y/N
(used only on TPAD)
N
Rtytm
(Retry Timer) (sec)
15–255 60
Rty#
(Retry Number)
0–255
0
(indefinite)
Conn
(Connection)
I D
00–ff none
Table 9-1 BSC Interactive Port Parameters
Parameter Valid Values Default Value