Cabletron Systems MMAC-Plus 9F116-01, User Manual, Page: 206 / 420

10-10 FRX/FRM 3. 3 User G uide, Rev 04
Async PAD Port Parameters
1
At line speeds of 38.4K bps or higher,
RTS/CTS H/W Flow Contr ol
should be
Y
.
Port Type
defines the protocol the port will support. Selecting this parameter will display a list
of valid protocols. An FRX4000 port can be configured as any WAN protocol loaded
in the device. An FRX6000 or FRM port can be configured as any WAN protocol con-
figured on this port's RLP. (Protocol configuration is described in Chapter 4.)
Table 10-3 Async Port Parameters
Parameter Valid Values Default Value
Port Type
see explanation
X.25
Physical Port Interface
see explanation see explanation
Blocked Port Flag Y/N N
X. 3 Line Speed see explanation
1
none
Initial Profil e Nam e
0–10 characters
90
Login Required Y/N Y
Parity 0–3 0
DCE Cable Attached Y/N N
Mask Link Alar ms Y/N N
On-line Sys. Memory Changes Y/N N
Generate M-bit packets Y/N N
Defaul t Calling Address valid Subscriber ID none
Disable X.121 User Call s N N
Autocall Y/N N
Autocall Delay
(sec)
0–255 0
Cal led Address valid subscriber ID none
Retry Count 0–10 (0
= retry indefinitely)
5
Retry Interval (sec) 0–255 60
User Data
(ASCII) 0–12 characters none
Facilities (hex) 0–28 characters none
DTR/RTS Active when VC Up Y/N N
Input Signal Detection 0–5 1
(DSR)
RTS/CTS H/W Flow Control Y/N
1
N
Disconnect Ti mer (min) 0–60 (0 = disable timer) 2
Disconnect Durati on
(sec)
0–300 0
Timeout i f No Login Y/N N
Timeout i f No Call Y/N N
Timeout i f No Data Y/N N
Disconnect i f Cl ear Recvd Y/N N
Disconnect i f Cl ear Sent Y/N N