Bosch Rexroth OptiFeed-FS EcoDrive 03 FLP04VRS, Functional Description

Page: 50 / 490

4-12
General Instructions for Start-Up ECODRIVE03-FL*-04VRS
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
Address Register Card
•
Enter the address set with the S2 and S3 dials on the drive
controller.
Language Register Card
•
Select language.
3. Press Connect button and wait for connection to be made.
If no connection is made, the baud rate and address can be
determined by using Serial/Scan. If no device is found that way, check
the serial cable.
4. Using Serial/Firmware Info the four headers of the programmed
module are read. (You can view the headers that were read by
selecting the Header register card.)
5. Press Transmit button.
Å
The standard Windows dialog for opening a file is shown.
6. Select the *.ibf file to be updated and open file.
7. Press Send button.
Å
If "Modules - all" is selected, the entire IBF file is programmed
without asking for confirmation (normally, the firmware FWA-
ECODRIVE03-FLP has four firmware modules). If Modules
"Module - Single" is selected, you must press Send again after
each firmware module has been programmed.
8. After successful update, press the Disconnect button.
Å
The drive firmware is started.
9. Close Dolfi.
Å
If the number of parameters to be buffered has changed, "PL" is
displayed. (If errors are present, they must first be cleared). If the
S1 key is pressed, all buffered parameters are re-set to their
default values. During this time, "C8 Load Default Parameters" is
displayed.
If the command "C8 Load Default Parameters" is started or the
motor type is changed, "UL" is displayed. (If Parameter Mode is
pre-set, it must first be exited.) Press the S1 key or initialize the
Clear Errors command. Then, the controller default settings are
loaded from the motor feedback to the drive controller.
10. Setting the correct address for the drive controller
11. Load the desired parameter/program file.