FSN Series • User’s Guide
73
3. Control Panel Orientation
Control Panel Descriptions
~
Key 2 Source
— (directly above the
KEY 2
button), indicates the current
source assigned to
KEY 2
. When you select another source for
KEY 2
on the
Key Bus
, the source label updates.
~
Current Transition Rate
— indicates the auto-transition rate loaded in
the M/E. This rate is used by the
AUTO TRAN
,
MIX KEY 1
and
MIX
KEY 2
functions. Use the
Transition Menu
to change rates. In
” section on page 134 for details.
2) T-Bar and Transition LEDs
The
T-Bar
provides manual transition control for the layers enabled in the
Next
Transition Group
. For both manual and automatic transitions, the
Transition
LEDs
indicate the position of the transition in progress.
Figure 3-13.
T-Bar and Transition LEDs
T-Bar
functionality is identical for the M/E and PGM banks. In Chapter 7, refer to
the “
Understanding the T-Bar and Transition LEDs
complete details.
3) Next Transition Group
The three buttons in the
Next Transition Group
indicate which specific
combination of M/E layers is enabled (or “armed”) for the next transition. The
state of these buttons affects the M/E’s “lookahead” preview output.
Figure 3-14.
Next Transition Group
To use the group, simultaneously press the combination of buttons that you wish
to enable. Any combination can be pressed. Whichever combination you enable
automatic disables those buttons that were not pressed.
For example:
S
If
BG
,
KEY 1
and
KEY 2
are currently lit, pressing
BG
turns the
BG
button on, and turns off the
KEY 1
and
KEY 2
buttons.
S
If
KEY 1
is currently lit, simultaneously pressing
BG
and
KEY 2
turns the
BG
and
KEY 2
buttons on, and
KEY 1
off.
Note
Remember that the
SEL
button chooses the active key bus,
as indicated by the
Key Control LEDs
.
T-Bar
Transition
LEDs
BG
KEY
1
KEY
2
