FSN Series • User’s Guide
247
6. System Setup
Communications Setup
`çããìåáÅ~íáçåë=pÉíìé
FSN Series system setup:
Step 5
In this procedure, you will set up communication between the FSN-1400 and the control
panel.
S
Prerequisite
— Ensure that you are familiar with the
Communications
Setup Menu
. In Chapter 5, refer to the “
”
section on page 175.
Use the following steps to set up communications:
1.
In the
Menu Bar
, press
{System}
to access the
System Menu
.
2.
Press
{Com Setup}
to display the
Communications Setup Menu
.
3.
Review the data in the
Ethernet Status Table
, and ensure the following:
~
FSN-150 Ethernet 1:
Connected
~
FSN-1400 Ethernet:
Connected
If status is “
Connected
,” communication is properly set up. Please continue with
the “
Reference Video and Output Setup
” procedure on page 248.
4.
If status is “
Not Connected
,” press
{Discover FSN-1400}
to locate the IP
address(es) of all FSN-1400 units
within your local network.
~
If the pop-up alerts you that no FSN-1400 units have been discovered,
check all Ethernet connections, then press
{Discover FSN-1400}
again
to re-try the procedure.
~
If FSN-1400 units are discovered, the
FSN-1400 Selection Keypad
appears. Select the desired
FSN-1400
, and press
{Connect}
.
5.
(Advanced)
If you need to change the IP address of a highlighted port, for
example, if your system is connected to a house network, press
{Set IP Address}
to display the
IP Address Keypad
. Enter the desired address and press
{Enter}
.
6.
(Advanced)
If you need to change the subnet mask of a highlighted port, press
{Set Subnet Mask}
to display the
Subnet Mask Keypad
. Enter the desired
subnet mask and press
{Enter}
.
7.
(Advanced)
If you need to return a highlighted port’s IP address and Subnet
Mask to their factory default values, press
{Return to Default}
.
5
Important
If communication is not properly set up, numerous buttons will
be grayed out on the
System Menu
. These buttons will
activate once communication is properly set.