Barco FSN Series, User Manual

Page: 79 / 344

FSN Series • User’s Guide 79
3. Control Panel Orientation
Control Panel Descriptions
2) Aux Source Row
The Aux Source Row provides all the sources available on the switcher’s main
buses. Here, you select sources to route to the outputs that you select on the Aux
Output Row . This is the row where you complete source-to-output assignments.
The following rules apply:
~
On the FSN-150, sources 11 through 20 are accessed via SHIFT .
~
Source assignments on the row can be changed at any time.
~
In addition to dedicated sources, additional clean feed sources are
available via the
ASSIGN button. See below for details.
~
Only one button on the Aux Source Row can be lit at a time. This
button indicates the source that is assigned to the selected Aux output.
In the figure below, source 2 is assigned to Aux output 2:
Figure 3-18. Sample source-to-output assignment, FSN-150
3) Assignable Source
In addition to dedicated sources on the Aux Source Row , one additional clean
feed source can be mapped to the ASSIGN button. The following sources are
available:
~
M/E 1 out clean — pre KEY 1
~
M/E 1 out clean — pre KEY 2
~
Program out clean — pre DSK
To assign a clean feed source to the ASSIGN button, press and hold the ASSIGN
button, then use the Clean Feed Setup Menu . In Chapter 5, see the “ Clean
Feed Setup Menu ” section on page 184 for details.
In Chapter 7, refer to the “ Working with Aux Buses ” section on page 299 for complete
instructions on using Aux buses.
Note The sources on the Aux Source Row are identical to those
on the switcher’s main buses. If a button map is changed on
the main rows, it also changes on the
Aux Source Row .
AUX
BLACK
1
9
2
10
3
11
4
12
5
13
6
14
7
15
Aux Source Row
Aux Output Row
ASSIGN
Important
Only one clean feed source can be mapped to the ASSIGN
button for all Aux buses. For example, you cannot map “ Pre
KEY 1 ” to Aux 1, and “ Pre KEY 2 ” to Aux 2.