104
FSN Series • User’s Guide
4. Installation
Card and I/O Installation
fLl=m~åÉä=fåëÉêíáçå
To insert an I/O panel:
1.
Use
on page 103 to verify the slots in which the cards and their
corresponding I/O panels can be installed. Front and rear slot numbers will
match. For example, if you install a
NIC
in front slot
1
, its corresponding I/O panel
must be installed in rear slot
1
.
2.
If a blank I/O panel is installed in the target slot, loosen the two captive thumb
screws in the blank panel, remove it, and store it safely.
3.
Ensure that the selected I/O panel is properly oriented:
~
NIC
: orient the
SDI
label at the top.
~
UIC
: orient the label “
1
” at the top.
4.
Using the nylon guides in the chassis for alignment, carefully insert the I/O panel
into the chassis. Be sure to push on both the top and bottom thumb screws
simultaneously, until the card is fully seated in the FSN-1400 chassis connector.
5.
Once the panel is fully seated, tighten the two thumb screws.
6.
Repeat from step 1 for all additional I/O panels that you want to install.
fLl=m~åÉä=oÉãçî~ä
To remove an I/O panel:
1.
Loosen the two captive thumb screws in the I/O panel, and carefully remove it
from the FSN-1400 chassis. Store the panel safely for later use.
2.
Install a blank panel in its place.
3.
Repeat from step 1 for all additional I/O panels that you want to remove.
Caution
Always push both thumb screws simultaneously. If you only
push on one, you can damage the panel or bend a pin.
Important
Unused rear I/O slots must always have blank panels
installed.
