FSN Series • User’s Guide
109
4. Installation
Signal Connections
lìíéìí=`çååÉÅíáçåë
The figure below illustrates the output connections on the
M/E
card’s I/O panel:
Figure 4-15.
Output connections
Use the following steps to connect output signals from the FSN-1400’s
M/E
card.
1.
The
Program Out 1
and
Program Out 2
signals are identical. Connect to a
monitor, and to your target destination device as required.
2.
Connect
Preview Out
to a monitor. This output provides the Program bank’s
“lookahead” preview video. In Chapter 7, refer to the “
” section on page 274 for additional information.
3.
Connect
Clean Out
to a monitor or the desired destination. This output provides
the system’s main clean feed signal. In Chapter 2, refer to the “
” section on page 46 for details.
4.
Connect
M/E 1 Program Out
to a monitor or the desired destination. This output
provides M/E 1’s program output signal.
5.
Connect
M/E 1 Preview Out
to a monitor. This output provides the Program
bank’s “lookahead” preview video. In Chapter 7, refer to the “
” section on page 274 for additional information.
2
CLN
Fill
PVW
PVW
PGM
CLN
1
PGM
CLN
3
4
5
6
M/E
2
Cut
PVW
M/E
1
AUX
DSK
PGM
Program Out 2
Program Out 1
Preview Out
Clean Out
M/E 1 Program Out
M/E 1 Preview Out
M/E 1 Clean Out
M/E 2 Program Out
M/E 2 Preview Out
M/E 2 Clean Out
Note
All connections use BNC cables. All outputs are SDI (either
SD-SDI or HD-SDI).
