![background image](http://html1.mh-extra.com/html/barco/fsn-series/fsn-series_user-manual_3894029300.webp)
300
FSN Series • User’s Guide
7. Operations
Using Custom Control Functions
4.
To set the
ASSIGN
button source:
~
Press
{Assign Button}
. The
Palette
changes to the
Assign Button
flowchart.
~
Select the desired clean feed point for the
ASSIGN
button.
rëáåÖ=`ìëíçã=`çåíêçä=cìåÅíáçåë
The
Custom Control Section
provides groups of buttons that can be programmed to
perform various switcher functions.
S
Prerequisites
— Ensure that you are familiar with the
Custom Control
Section
. In Chapter 3, refer to the “
” heading on
page 80 for details.
Use the following steps to use
Custom Control
functions:
1.
To freeze a source:
~
Press and hold
FRZ
, then press the desired source button (on any bus).
Note that this is the same as toggling the
{Freeze}
button to “
On
” — on
the
Input Menu
.
2.
To un-freeze a source:
~
Press and hold
UNFRZ
, then press the button for the frozen source (on
any bus). Note that this is the same as toggling the
{Freeze}
button to
“
Off
” — on the
Input Menu
.
3.
To perform an auto transition on all banks simultaneously:
~
Press
ALL TRAN
. All banks will transition, each at their own selected
transition rate.
4.
To perform a on all banks simultaneously:
~
Press
ALL CUT
. All banks will cut immediately.
5.
To save all system settings:
~
Press
SAVE ALL
. All parameters under the
System Menu
will be saved
to non-volatile memory. Note that this function is the same as pressing
{Save All}
on the
System Menu
. In Chapter 5, refer to the “
section on page 220 for a list of the functions that are saved.
Note
Remember that only one clean feed source can be mapped to
the
ASSIGN
button for all Aux buses. For example, you
cannot map “
Pre KEY 1
” to Aux 1, and “
Pre KEY 2
” to Aux 2.
Note
In release 1.0, only pre-programmed “system” functions such
as
ALL TRAN
,
FRZ
,
UNFRZ
, etc., are available.