Variable
Value
ASCII. The group name must begin with a letter within
the range a..z or A..Z.
clfr-type <classifier | block>
Specifies the classifier type; classifier or block.
clfr-id <1-55000>
Specifies the classifier ID; range is 1–55000.
clfr-name <WORD>
Specifies the classifier name or classifier block name;
maximum is 16 alphanumeric characters.
in-profile-action <1-55000>
Specifies the action ID for in-profile traffic; range is 1–
55000.
in-profile-action-name <WORD>
Specifies the action name for in-profile traffic;
maximum is 16 alphanumeric characters.
meter <1-55000>
Specifies meter ID associated with this policy; range
is 1–55000.
meter-name <WORD>
Specifies the meter name associated with this policy;
maximum of 16 alphanumeric characters.
non-match-action <1-55000>
Specifies the action ID for non-match traffic; range is
1–55000. This parameter is not applicable to 5600
Series switches.
non-match-action-name <WORD> Specifies the action name for non-match traffic;
maximum is 16 alphanumeric characters.
precedence <1-15>
Specifies the precedence of this policy in relation to
other policies associated with the same interface
group. Enter precedence number; range is 1–15.
Note: Policies with a lower precedence value are
evaluated after policies with a higher precedence
number. Evaluation goes from highest value to
lowest.
track-statistics <individual |
aggregate>
Specifies statistics tracking on this policy, either:
• individual—statistics on individual classifiers
• aggregate—aggregate statistics
Removing QoS policies
About this task
Use the following procedure to disable QoS policy entries. Policies can be enabled using the
qos policy <policynum> enable
command.
Procedure
Remove QoS policy entries by using the following command from Global Configuration
mode.
ACLI Reference for wired networks
340 Avaya WLAN 8100 CLI Reference
August 2013